Tangent and Albany Auto Repair

(541) 248-1346
Mon - Fri: 8:00 AM - 5:00 PM

Yearly Archives: 2020

My car is pulling when I drive

This pulling could be due to your vehicle being out of alignment. When your wheels and tires are not in proper alignment it can cause a pull to either one side or the other. This can happen due to rough roads, pot holes, and curbs. If left for to long it can damage your tires and cause premature tire wear. We recommend to have an alignment performed once a year to make sure you're driving straight down the road. Give us a call and let us take care of you.  Happy Adventures,  Heather

Categories:

Alignment

My check engine light is on

Your check engine light can come on from anything as simple as a gas cap to an electrical failure and everything in between. The only way to know why it's on is to have a diagnostic test performed to find out why and what needs to be done to keep you on the road. This is not the same thing as a quick scan. While a quick scan is convenient it will not always tell you what the problem is. Let's say you have a misfire code. This you would think means that you need new spark plugs and this could be true, but what if you just had a tune up and this is now coming back. Your spark plugs are probably fine it most likely an issue with one of the other ignition components. This requires a test to find out which one it is. I wouldn't want you to go through the process and expense of another tune up when it's not needed. Give us a call and let us take care of you.  Happy Adventures,  Heather

My battery keeps dying

If your battery keeps dying then it could be due to an issue with the electrical issue. Most newer cars have many modules that control the cars function - from the starting system to the stereo. If one of these modules refuses to turn off then it will cause a draw and that can make your battery die. To find our why we need to do a pin point test to eliminate modules. This can take some time as some vehicles will have 20+ modules. Once the corrupt module is found we can decide if it needs to be replaced or possibly reprogrammed. Give us a call and let us take care of you.  Happy Adventures, Heather

My check engine light is on and my car is shaking

Your check engine light and your vehicle shaking could be due to the same issue. You could have a misfire causing both of those symptoms. When your vehicle is not firing properly then it can cause your vehicle to shake. This fault will also cause the check engine light to come on. Typically we see when your tune up is overdue or if it has a leak that has caused the spark plugs to be covered in oil. Give us a call and let us take care of you.  Happy Adventures,  Heather

When I turn the key my pickup won't start it just clicks

This could be due to an issue with your starting system. If your starting is fail then when you go to start your engine it will make a click noise. Of course there could be a secondary issue along with the starter, but most of the time we find it is a simple fix. Give us a call and let us take care of you.  Happy Adventures,  Heather

Categories:

Starter

My car overheated while driving

Anytime that your vehicle's engine overheats it can be damaging to your engine components. The engine coolant is a vital component to keep your vehicle running as it should. This could be due to a water pump that has failed and is no longer pumping coolant through the cooling system. This would cause your engine to overheat. If a faulty water pump is causing your overheating issue then your water pump will need to be replaced. Give us a call and let us take care of you.  Happy Adventures,  Heather

Categories:

Overheating

My Ford 7.3L diesel is running rough

This could be due to an issue with your valve cover gasket harness. The harness has clips that are made of hard plastic. Over time this can become brittle from heat and age. When the clip come undone it can cause your pickup to have a misfire on an injector, or a starting issue with your glow plugs. This is due to a lack of connection. The fix is to replace the valve cover gasket and harness. This should solve the misfire and your pickup will run as it should. Give us a call and let us take care of you.  Happy Adventures,  Heather

Categories:

Diesel

My heater only blows hot on one side

This is most likely due to a faulty blend door actuator. Over time the components of the blend door actuator can wear out and it will stop working. At times it could stick causing it to only blow cold air or hot air. In order to fix this and for your vehicle to be the temperature that you want it to be it will need to be replaced.  Give us a call and let us take care of you.  Happy Adventures,  Heather

Categories:

heating

My service tire pressure message is on

This is mostly likely due to a fault with one of your TPMS sensors. Your TPMS sensor is short for your Tire Pressure Monitor Sensor. This sensor monitors the air pressure in your tires. If one of your tires is below the pressure it should be or if it is over inflated the light will come on. This can also happen if one of the batteries in the sensor stops working. The batteries typically last 3 to 5 years. I usually recommend to have the sensors replaced when you have new tires installed on your vehicle. It saves you time and a second trip to have it replaced. Did you know that here at J & H Automotive we can take care of that for you. We can! Give us a call and let us take care of you.  Happy Adventures,  Heather

Categories:

Tire light

My check engine light came on and my car is running rough

Your check engine light can come on due to many faults that can happen to your vehicle. From the engine, to the transmission to brake issues and electrical systems. If this happens and your engine is running rough then it could be due to a component within your ignition system that is causing the issue. You need to make it an appointment to have it diagnosed to make sure the correct component is being replaced. Give us a call and let us take care of you.  Happy Adventures,  Heather

J & H Automotive, Inc is committed to ensuring effective communication and digital accessibility to all users. We are continually improving the user experience for everyone, and apply the relevant accessibility standards to achieve these goals. We welcome your feedback. Please call J & H Automotive, Inc (541) 791-2886 if you have any issues in accessing any area of our website.